When the industrial aluminum material is framed, attention should be paid to the way and method when the frame, such as the long section of the cantilever, the thin wall material, the circular arc material, the open material, the solid small section material, the plate, the high requirements for the surface, the interlocking, and the non easy separation, as well as the necessary auxiliary tools, the lining paper bushing and so on. The pads should be arranged on the upper and lower sides, with the correct arrangement, suitable spacing and suitable quantity, which can withstand the quality and certain afterburner of the industrial aluminum profile. The profile of the frame must be piled up.
Attention should be paid to the position of industrial aluminum materials stacked in the frame, so as to avoid the weight of both ends, resulting in accidents such as stacking and sliding of profiles. Pay attention to sawing speed, burr of sawing surface, observe the size of the sawing oil and adjust the material of the saw. During the sawing operation, attention should be paid to avoid accidents of personal safety and injury. During sawing, it is strictly prohibited to exert force on the outside side of the section two, so as to avoid cutting the saws in the cutting saw, causing the material to take place, and instantly damaging the material and hurting people.
Notice that the aluminum scrap should be blown clean, the burr should be scraped out, the interval should be appropriate, the lifting should be safe, the stack frame should be aligned, and the number of stack frames should not exceed the requirements of the four layer quantity stipulated by the company.